Losi 5ive brushless motor mount

Losi 5ive brushless motor mount*photo is pre production mount, the wfo logo was flipped 90 on the production mounts but they are the same other than this cosmetic change. This is our Losi 5ive motor mount. This fits the 5ive platform (5ive t, 5ive t 2. 0, and 5ive b). The rear ring is available in different sizes to fit the different motors available. The mount will come with all needed hardware except the screws that go in to the motor from the front plate. Four washer head screws

*photo is pre-production mount, the wfo logo was flipped 90° on the production mounts but they are the same other than this cosmetic change.

This is our Losi 5ive motor mount. This fits the 5ive platform (5ive-t, 5ive-t 2.0, and 5ive-b). The rear ring is available in different sizes to fit the different motors available. The mount will come with all needed hardware except the screws that go in to the motor from the front plate.

Four washer head screws will be included to mount it to the chassis.

Please measure your motor to be sure you purchase the correct size ring.

Castle 2028 sensored motors are 56.25mm

Castle 2028 non-sensored motors are 57mm

Leopard and some TP (with fins) are 57.8mm

Lehner is 60mm

On the 5ive-t 1.0 and 5ive-b with the stock 58t spur this should fit around 12-26t pinions.

On the 5ive-t 2.0 with 62t spur this should fit a 14 or 15t pinion and up to around a 23t.

*Motor size can change these estimates so these are just to be used as a possible range this mount is capable of supporting.